Have you been searching for information on the best surge protector? Your search is over, in this article we will cover all you need to know about surge protectors and so much more.
A transient voltage or power surge is a significant increase in voltage above its designated level during the flow of electricity. In the US, the normal voltage is 120, if this rises, this could be hazardous to electronic equipment. The increase in voltage that lasts only for three nanoseconds is referred to as surge, while when it lasts only for 1 or 2 nanoseconds, it is referred to as spike. When the spike or surge is very high, it will cause the wire to burst. This in turn will inflict damage to your electronic equipment. Even if it will not automatically break the machine, the strain will wear it down over time. Get a surge protector that will provide complete protection to your equipment. Choose the one that has inputs for telephone, computers, switches, lights and other kitchen equipment.
Important Features on the Best Surge Protector
One important feature that you need to consider before finally deciding to buy surge protector is the volt clamping which is ideal at 400. The best surge protector must also have a sine wave tracking which allow spikes to be clamp against it. This will prevent the spikes to rise too high. Some surge protectors have a 5 nanosecond response time which is very slow. The more acceptable is the one which can respond in less than one nanosecond. It should also contain the safety diagnostic light. This LED lights warn you about safety features such as wiring configuration of the receptacle is proper, the power is on, protection is present and enough ground path where the hazardous spikes can be diverted. That device that does not have this will not tell you of this critical safety features until the damage has already been done. The joule rating should also be higher for a more effective surge protection.
How to Install your Best Surge Protector?
In installing your new best surge protector, carefully pull out the old outlet in the wall box. The three wires of the outlet should be unscrewed. Straightened the ends of the wire and remove ½ inch of the insulation from the end of the white and black wires. On the surge protector, take out the wires and spread them away from each other. This is better so that you can work on each individual wire properly. Separating them will also reduce your risk of getting yourself a nasty shock. Using a wire nut, connect each pair of wire together firmly. The white wire on the outlet should be paired with the white one on the protector. The bare copper in the outlet should be joined with the wire in the protector which could either be green or bare copper color also. The black wire should be connected to the wall box and the back of the outlet. Then return the outlet in the box making sure that wire ends are not loose and they should not be touching each other. Knowing how to install your best surge protector is vital as it will avoid damage to your electronics in case of sudden fluctuation of power.
